Attention: Acrylic surface after long-distance transport will have individual scratches, Perfectly buyer carefully buy it.

Package size: 17"x14.5"x2" (44*37*5cm)

Gross weight：3KG(6.6lb)

Installation instructions

Tools Required: Pencil, Ruler, Jigsaw, Drill, Square, Screwdriver, Tape measure

A) Step 1

Cut out the template provided and position on the door ensuring it is in the center of the door. To determine the height of the hole measure the belly height of your pet Average installation height is 10-15cm from bottom of door). Position the template on your door and outline the template with a pencil and ruler ensuring your draw strange lines using a square. If the position of the template line is suitable then remove door from hinges and place on sawhorse to arrange cut our of pet door opening.

B) Step 2

Before cutting out the open drill pilot holes in each corner, Using a 2/5in timber drill bit drill out the pilot holes in each corner. Then using a jisaw start cutting from one corner following the template line to each corner until the opening is cut out.

C) Step 3

Before fitting the pet door, temporarily place the pet door with its frame cover on the exterior of the door. This will allow you to mark screw holes so they line up with the frame cover, Remove the pet door and drill the holes. Check the length of the screws against the width of the door to ensure that they are not too long. For hollow doors use the 4pcs plastic sheets on the inside of the pet door to cover the hollow openings inside the door. Position the pet door into place and then tighten the screws using a screwdriver.

1 set of Petsafe Plastic Pet Dog Door Freedom Extra Large door (021231)

Item# Description QTY Unit Note 021231 Petsafe Plastic Pet Dog Door Freedom Extra Large door 1 Set