|
1. Prepare and check the work before the operation.
2. Open the movable cover plate: Press down the handle of the plate
to open the movable cover plate and open the container cover.
3.
Check the height of the adjusting screw in the container is
suitable or not: The nail feeding tray has four sections of height
to be adjusted, and the height is adjusted according to the length
of the nail. Disc seat height adjustment screw, screw rotating disc
will be pulled up to an appropriate height and then fixed down. The
length scale of the nail can be adjusted according to the inner
side of the nail box.
4. Nail gun loading: The screw is placed on the adjusting nail
plate in the position of the staple length adjustment shaft of the
container. The second nail is placed at the front end of the nail
claw, and the front end of the nail is pulled out. Nail must insert
needle pin groove.
5. Close container cover: Close the movable cover plate. Confirm
whether the board is in the fixed hole of the nail head. (If there
is no access to the nail head fixing hole, check again to determine
whether the nail tip inserted into the nail head a trench).
6. After
installed, pay attention to the using between the insurance rack
and the trigger.
|
